3.8.1 Open Wi-Fi configuration
Opening Wi-Fi configuration
The usual entry is the Wi-Fi icon in the top toolbar—click it to open the current device’s Wi-Fi dialog.
When you first add a device, the add-device wizard can jump to the Wi-Fi step. To review defaults later, visit Configuration center → Device connection.
Reading connection status
The top Wi-Fi icon reflects the active device roughly as:
| State | Meaning |
|---|---|
| Connected | On Wi-Fi; network name is shown |
| Disconnected | No usable Wi-Fi link right now |
| Connecting | Scanning, associating, or obtaining an IP |
| Failed | Wrong password, weak signal, router policy, or DHCP issue (among others) |
The Wi-Fi dialog shows steps and failure messages. Usually verify first: password, distance to the router, and whether new clients are allowed.
Troubleshooting with Moss
Prefer entering SSID/password in the Wi-Fi dialog itself. When connection fails, paste the on-page hint into AI Dock—for example:
This board failed to join office_2.4g; logs stop at DHCP. Help me debug.
To debug another board (not the active one), switch the target in the composer or name the device in your message.